XXitanium

https://danny-chung.medium.com/please-stop-sharing-this-password-chart-514d516ccc96 https://themillergroup.com/strong-password/

@SwampNut ...any thoughts on these? Would one be adding personal info to a list to target, or are these websites safe? "Is your personal email address possibly compromised?" https://haveibeenpwned.com/ Password strength. ...this one, not just collecting passwords? (Yes, I'm paranoid, the interwebs are not out to get me.) https://bitwarden.com/how-secure-is-my-password/ I like my two-factor authentication and I almost never "remember my device" or "register". ...less info for bad guys to scrape.

https://snapchat.com/t/huhPDSVk CAT swap.

I could use 6.

I just shopped a hat to NZ for $20, just sayin' ...depending on what you need.

@poida @Banshee @paul99xx

The open-end pictured wasn't doing it. Not enough leverage.

The one on the back of the slide-pin. It was the one that was stuck. I had to take the whole bracket uot as I didn't have the right reducer/socket to put on the impact. I clamped it onto the bench and put a pipe on a 1/2" breaker bar to persuade it. (the kid asked me if we should buy some adaptors too 😳 )

I really don't, but the breaker-bar wasn't doing the job. It was "a bad reach" and I have had back problems in the past. O'REILLY'S made sure I got the part after hours. It should be covered under lifetime warranty.

Little brother was plenty, spun right off. Not even a strain on my limp old wrist.

@superhawk996 F250 front caliper, salt corrosive environment. Is that 1/2" Milwaukee capable of twisting off the head? I am doubting it. ...no.2 son...

...waiting on a regen at work. Facebook Haven't had time to decipher, but sounds interesting.

$500, it's beastly looking

My kid bought a big 1/2" Milwaukee with like 1,700-ish ft-lbs.

Look at Linux requirements for RAM and speed. They may be less than Microsoft, etc. Did your friend say what build of Linux they were interested in? Is the budget very small?

Ok Google - "big, nasty, mofo Ryobi" 1,170 ft-lbs

I have a really cheap 3/8" generic. Current project is removing passenger front caliper on the F-250 that has habitated our driveway for like 14 years. I want something new and better, 1/2", economical, but not junk. ...son no. 2 says get a Milwaukee. I have a DeWalt XR "set" with a small hex impact. I could try to match it? Any favorites, or war stories to share?

...from my son.

Ima go look for the "I'm Not a Real Biker" thread. I guess I didn't think there were rockers, but I've never felt the need to know what the inside of theses engines look kike. They're a Honda.

I had to go look.

Oxyclean

I was just 100 yards away from the factory.