Jump to content
CBR1100XX.org Forum

Parting out '98 BlackBird


Recommended Posts

Basically it was stored outside in Florida sun for quite a long time, some parts have seen better days, some are mint/intact...Motor is trash, but there are few good things in it or on it...gauges are very good, full Yoshi pipe very nice (needs cleaning/polishing) very small dent underneath, on one of the header pipes, rotors, calipers, masters, clutch slave, plates w/pressure plate, starter, seat (needs new cover), subframe, shock, swingarm, harness etc....check photos, if you need photos/close ups or higher resolution - send me an e-mail or PM me...Plase dibs in this thread if interested. Number of my posts not saying much about me but if you would feel more comfortable dealing with me over e-bay - no problem, PayPal is cool, you pay actual shipping cost.

Updated list of parts available:

Yoshimura RS-3 full system $300

Gauges $200

Air-box with K&N filter $25

Front rotors (12xxx miles) $100

Front axle $20

Right rear set (rear brake lever, bracket, peg, master w/res.) $35

Swingarm w/pivot bolt $40

Passenger brackets (both, right side have peg) $30

Rear axle $20

Calipers $50

Front brake master w/lever $35

Right clip-on w/bar end $15

Lower triple $35

Water pump $30

Starter $35

Stator $40

Subframe $70

Lockset (gas cap, ignition switch, seat lock, key) $75

Left side switches w/choke cable $20

Right side switches w/throttle assy. cables $20

Rear shock (12xxx miles) $35

post-2063-1262917948.jpg

post-2063-1262917979.jpg

post-2063-1262918006.jpg

Link to comment
Share on other sites

plastics around the guages and between tank and fairing, both sides.

left side (gear change side) drivers footpeg

Link to comment
Share on other sites

A big thanks to the seller for taking the time to send me pics of the lower center fairing and understanding what a fussy SOB I am....He convinced me to buy new...so, the lower center is still available and a bump for a good guy...Hank

Link to comment
Share on other sites

Basically it was stored outside in Florida sun for quite a long time, some parts have seen better days, some are mint/intact...Motor is trash, but there are few good things in it or on it...gauges are very good, headlight, full Yoshi pipe very nice (needs cleaning/polishing) very small dent underneath, on one of the header pipes, wheels, rotors, calipers, masters, clutch slave, plates w/pressure plate, starter, l & r fairings, upper, gas tank, tail section, seat (needs new cover), subframe shock, swingarm, harness etc....check photos, if you need photos/close ups or higher resolution - send me an e-mail or PM me...Plase dibs in this thread if interested. Number of my posts not saying much about me but if you would feel more comfortable dealing with me over e-bay - no problem, PayPal is cool, you pay actual shipping cost, no rape here.

Updated list of parts available:

SALE PENDING (still taking dibs)

Left side fairing

Stator cover

Rear cowl/tail section

Gauges???

Clutch master, line, slave??

100% Available:

Yoshimura RS-3 full system (have dibs TL7484)

Gauges (have dibs OrganDonor)

Front wheel

Rear wheel w/rotor, sprocket

Carbs (nice)

Air-box with K&N filter

Front rotors (12xxx miles)

Front axle

Right rear set (rear brake lever, bracket, peg, master w/res.)

Swingarm w/pivot bolt

Passenger brackets (both, right side have peg)

Rear axle

Calipers

Front brake master w/lever

Right clip-on w/bar end

Lower triple

Water pump

Starter

Stator

Subframe

Seat (needs new cover)

Lockset (gas cap, ignition switch, seat lock, key)

Left side switches w/choke cable

Right side switches w/throttle assy. cables

Rear shock (12xxx miles)

I am new to this website and would like to get the entiire rear wheel assembly as well as the caliper. please advise what I need to do to make this happen

Link to comment
Share on other sites

I am new to this website and would like to get the entiire rear wheel assembly as well as the caliper. please advise what I need to do to make this happen

Here is a link to the rear wheel. http://cgi.ebay.com/ebaymotors/1997-98-CBR...=item4a9db1e3df Or PM him for further details

Link to comment
Share on other sites

Basically it was stored outside in Florida sun for quite a long time, some parts have seen better days, some are mint/intact...Motor is trash, but there are few good things in it or on it...gauges are very good, headlight, full Yoshi pipe very nice (needs cleaning/polishing) very small dent underneath, on one of the header pipes, wheels, rotors, calipers, masters, clutch slave, plates w/pressure plate, starter, l & r fairings, upper, gas tank, tail section, seat (needs new cover), subframe shock, swingarm, harness etc....check photos, if you need photos/close ups or higher resolution - send me an e-mail or PM me...Plase dibs in this thread if interested. Number of my posts not saying much about me but if you would feel more comfortable dealing with me over e-bay - no problem, PayPal is cool, you pay actual shipping cost, no rape here.

Updated list of parts available:

SALE PENDING (still taking dibs)

Left side fairing

Stator cover

Rear cowl/tail section

Gauges???

Clutch master, line, slave??

100% Available:

Yoshimura RS-3 full system (have dibs TL7484)

Gauges (have dibs OrganDonor)

Front wheel

Rear wheel w/rotor, sprocket

Carbs (nice)

Air-box with K&N filter

Front rotors (12xxx miles)

Front axle

Right rear set (rear brake lever, bracket, peg, master w/res.)

Swingarm w/pivot bolt

Passenger brackets (both, right side have peg)

Rear axle

Calipers

Front brake master w/lever

Right clip-on w/bar end

Lower triple

Water pump

Starter

Stator

Subframe

Seat (needs new cover)

Lockset (gas cap, ignition switch, seat lock, key)

Left side switches w/choke cable

Right side switches w/throttle assy. cables

Rear shock (12xxx miles)

I am new to this website and would like to get the entiire rear wheel assembly as well as the caliper. please advise what I need to do to make this happen

PM sent....Thanks

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

Terms of Use