Basically it was stored outside in Florida sun for quite a long time, some parts have seen better days, some are mint/intact...Motor is trash, but there are few good things in it or on it...gauges are very good, full Yoshi pipe very nice (needs cleaning/polishing) very small dent underneath, on one of the header pipes, rotors, calipers, masters, clutch slave, plates w/pressure plate, starter, seat (needs new cover), subframe, shock, swingarm, harness etc....check photos, if you need photos/close ups or higher resolution - send me an e-mail or PM me...Plase dibs in this thread if interested. Number of my posts not saying much about me but if you would feel more comfortable dealing with me over e-bay - no problem, PayPal is cool, you pay actual shipping cost.
Updated list of parts available:
Yoshimura RS-3 full system $300
Gauges $200
Air-box with K&N filter $25
Front rotors (12xxx miles) $100
Front axle $20
Right rear set (rear brake lever, bracket, peg, master w/res.) $35
Swingarm w/pivot bolt $40
Passenger brackets (both, right side have peg) $30
Rear axle $20
Calipers $50
Front brake master w/lever $35
Right clip-on w/bar end $15
Lower triple $35
Water pump $30
Starter $35
Stator $40
Subframe $70
Lockset (gas cap, ignition switch, seat lock, key) $75
Left side switches w/choke cable $20
Right side switches w/throttle assy. cables $20
Rear shock (12xxx miles) $35