snailrider Posted January 7, 2005 Share Posted January 7, 2005 I am confused as to where the lock is gripping, the gap inbetween the switch housing and the throttle sleeve, or directly on the sleeve toward the switch housing end of it? My NEP has the U shaped foot that snap into one of the throttle cable on a Bandit 12S, was installed by Ron of tailofthedragon at the Gap, but I pulled it off too quickly when I traded it in for an XX. It looked like the one toward the bottom of this link, a CC2 or CC4 I suppose. http://www.soundoffrec.com/docs/rqt0cbiqga...uise%20control' Thanks Joe Quote Link to comment Share on other sites More sharing options...
HERBXX Posted January 7, 2005 Share Posted January 7, 2005 It squeeses the throttle sleeve ..And the Tabs prevent the whole thing from turning. Quote Link to comment Share on other sites More sharing options...
ncblkbrd1100xx Posted January 7, 2005 Share Posted January 7, 2005 Cut off the u-shaped foot. Drill a small hole through the control and housing and secure with a small screw. Works much better! Quote Link to comment Share on other sites More sharing options...
snailrider Posted January 7, 2005 Author Share Posted January 7, 2005 Yes, I understand the purpose of the tab or U shaped foot, but when I close the two half-round arms together, I thought the inside circle is either too big for the handlebar or too small for the sleeve, but I could be missing something so obvious :oops: Quote Link to comment Share on other sites More sharing options...
Iceman_40 Posted January 8, 2005 Share Posted January 8, 2005 I used Epoxy to glue the tabs to the case, works great been on there all year, and 18,000K no problems... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.