XXCited

It would seem that the best way to handle this would be to have a priority on the inputs to mute the other sources. The detector would have the highest priority, cell phone 2nd, FRS radio 3rd and mps player none. That way whatever the source would have an uninterupted source. Is there anywhere someone could go to learn how to configure such a setup? New to electronics but this has peaked my interest. Also, how are the throat mikes for talking on an frs or cell while on a bike?

I think that the way they fit is different on each person but I just bought the tips from the ER-4 you mentioned($15 for 10, I think) and they fit on the Koss plugs with a little patience. BIG difference in fit & sound quality. Haven't had a change to try them on the bike yet (too cold) but I think they will work great. Total cost - aprox $30.

I don't have a chatterbox but I do have a pair of the Koss "the plug" earphones that fit in the ear canal. They are great for blocking out the wind noise and the fit means you don't have to have the volume up so much.

Does anyone know if there is a difference between the Canadian & US models for the digital dash? I thought there was a toggle switch to change between kph & mph but Warren said that he thinks the odometer stays in km. - Where could I find out?

Warren, You have PM

Thanks for all of the replies. Is there a difference what's involved for the '99 & newer bikes from the '97/98 models? In other words, is the conversion easier on the '99? I thought I read somewhere that on the '99 you only need to use a '01 wiring harness, switch the position of one wire and get a newer coolant sensor. But I can't seem to find out which wire...

Thanks for the reply. I have looked at Ron Ayers, Cost is about $500 - Quite a lot when the old dash works fine (I know that's what the wife would say) - Hoped to find a lower cost alternative

Not sure if this belongs in the Garage or in the Sales section. Does anyone have any knowledge on this undertail? Sounds like a good concept - includes the entire fender - may avoid clearance problems with a hugger??? http://cgi.ebay.com/ebaymotors/ws/eBayISAP...&category=35561

Does anyone have any ideas on a low cost source for a '01 or newer dash beside combing ebay? Also, does anyone have the details on the wiring changes needed?

Does anyone have the details on what wires need to be changed to make the change on a '99 - to a '01? I thought it was just one wire needed to be switched if you use a 2001 harnes and 2001 dash. Can MiDNiTXX or Elixxir :???:

I am new to posting on the site although I have been reading the site for a long time. I have a 99 Bird (the fast one) with a Corbin GF carbon fiber seat and a Erion CF exhaust. I would like to know what it would take to switch to the new dash. I searched for specifics on the site but could not find any details on the installation. I know that the dash, front wiring harness and coolant sensor need to be changed to an '01 model. Has anyone done it? Can you give me some details. Also any idea of cost?