Jump to content
CBR1100XX.org Forum

Cleaned out the garage and found these


Recommended Posts

I have a left side 2000 Titanium lower, only had about 4k miles on the bike when I removed it as I wrecked on the other side. Small minor rock chips that would be normal but otherwise good condition. The foam is still there but the black heat shield on the back was removed for my replacement plastics I had bought for the bike. I can get pics tomorrow once its light out. 100 obo plus shipping

Also found a brand new still in packaging speed link for the rear end for drag racing, adjust from stock high to slammed in minutes. 100 obo plus shipping

And last a Snitz Racing Front strap in red, dirty but very usable. Ill throw it in with the rear link.

I dont have my blackbird anymore so these have no use to me.

Im located in Port Richey FL.

Link to comment
Share on other sites

I have a left side 2000 Titanium lower, only had about 4k miles on the bike when I removed it as I wrecked on the other side. Small minor rock chips that would be normal but otherwise good condition. The foam is still there but the black heat shield on the back was removed for my replacement plastics I had bought for the bike. I can get pics tomorrow once its light out. 100 obo plus shipping

Also found a brand new still in packaging speed link for the rear end for drag racing, adjust from stock high to slammed in minutes. 100 obo plus shipping

And last a Snitz Racing Front strap in red, dirty but very usable. Ill throw it in with the rear link.

I dont have my blackbird anymore so these have no use to me.

Im located in Port Richey FL.

I'll take the left lower! Sent PM!

Link to comment
Share on other sites

I have attached the photos. I sent Steve and E-Mail as when I took down the plastic lower it wasnt as I remembered it. I sent him this E-Mail describing it. He still has first dibs, I just want to get the correct condition out there. I also didnt get a chance to take a picture of the strap as hell its free if you buy the link and its buried in the garage lol.

I pulled the left lower off the shelf and wiped off the cob webs and looked it over. As in the add the back black heat shield was removed to put onto my bike, I also forgot but I had removed the little metal tabs on the top that connect the lower fairing to the upper and the welnut that the front V shape center piece is screwed into. The foam is good and was never cut for frame sliders.

However I also went over the finish and it was not how I remembered it. Its been 2 years since I put it away. There was a considerable amount of tiny rock chips on the front area and the lower area(not deep just chips), there is also a scrap on the very bottom where the two lower are connected together, and a 1 inch minor scuff midway up the fairing. I took pictures, the tiny rock chips are really hard to get to show up, the scrap showed up well and you can also see that all tabs are perfect and this side was never dropped.

I like to go into as much detail as possible so there are no surprises when you get your part!

Dave

post-1427-1193403415.jpg

post-1427-1193403424.jpg

post-1427-1193403437.jpg

post-1427-1193403447.jpg

post-1427-1193403461.jpg

post-1427-1193403473.jpg

post-1427-1193403488.jpg

post-1427-1193403501.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

Terms of Use