Jump to content
CBR1100XX.org Forum

Help Bad Running After Plug & Air Filter Change


xxexcess

Recommended Posts

right having just changed the plugs and air filter it's now struggling to run, misfires, backfires, farts and pops, when i open the throttle it cuts out.

what the fcuk have i done wrong here, the vac lines,fuel lines are on in the right places fuel tap is on i have checked that i haven't got a plug lead round the wrong way all ok.

Seems to run better when the choke is on, i have made sure the filter box is sitting on the carbs ok and that the rubber rings are tight over the carb tops too.

Iain

Link to comment
Share on other sites

If it ran fine before your maintenance then it's something you did. You'll have to go back in there and check your work.

Vac lines may still be wrong, very easy to put one on the wrong spot on the petcock.

Crossed plug wires? One boot not fully on a plug?

Link to comment
Share on other sites

Errr pilot error, put the vac line on the petcock in the wrong place, duh. Why have 2 that look the same i will never know.

Thanks

Iain

The one is to allow the actual petcock to vent to atmosphere. ( the air in the diaphram, if you take the petcock apart you will understand and never put the hose there again.)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

Terms of Use