SLyFoXX

Still for sale, had a couple dudes look at her, but nothing serious

Try it again.

Reduced - time move this along

Bike is still up for sale, put the ad back up. Mystic does need to happen!

That would be for a new owner to share

It is Silver

She did it all on her own, seafoam and fresh gas did the trick

It's and friend of L's daughter, she bought it and I think she had a low speed crash and has not rode it since. A little up date:. She removed the old fuel and put fresh gas, bike now can run up to 5k before it begins to sputter. She's going to spray carb cleaner in the air box and see how much of an improvement that does, I assume it's making progress. With any any luck it will clean up with carb cleaner and seafoam.

L and I need to make a drive up to see you Tim, I'll call you next week been too long

Not mine but attempting help her out, from what I'm being told the bake has sat with a full tank of gas for 9 months. Bike will start and idle but once you open the throttle the engine dies. She is going to start by replace old fuel with new, what else? I assume the carburetor is glazed, what is the best way to remove the gunk in the carb?

I think it's around 26k for mileage, not sure if it's been lowered - not that I a ware of. Glen does keep his bike extremely clean. Great bike for someone. Sorry to see him move on.

Looks like This is Glenn's bike, how always took great care of his bike http://portland.craigslist.org/mlt/mcy/5697394375.html

pm sent

Unable to clean up this spot on the forks, is this critical?

I have not, if I continue to have trouble removing the bottom bolt I'll give that a try.

Thanks, I'll give this a go

I've used an cordless impact, I'll try to use the air compressor impact wrench

I'm in the process of replacing the front fork seals, leaking on one of the forks. A couple of issues that came up in the process first - bottom bolts will not release - one of them just spins and the other is locked solid - thoughts on how to get those off and do they need to come off to replace the seals? Second - the fork tubs are pretty rough, I've used wd40 in attempt to clean up the tubes, may actually be scratches. What are my options here. What is the best approach and what would be the economical approach

Toxxic, you need to jump on this now that you're back on a bird

What type of equipment/ are you using to mount and balance your own, considering doing this myself

I did, I guess no interest off to Craigslist

Thanks for clarifying that