Iceman_40 Posted June 10, 2014 Share Posted June 10, 2014 Found a few online listing different sizes. Anyone know what the right size is? Is that one it? Inside diameter is 34mm Outer diameter is 40mm Quote Link to comment Share on other sites More sharing options...
kiwimack Posted June 12, 2014 Share Posted June 12, 2014 I have one Brett (airborne) made up for me . You want to use it? Quote Link to comment Share on other sites More sharing options...
SR71BLACKBIRDXX Posted June 13, 2014 Share Posted June 13, 2014 I made one too if you need it Quote Link to comment Share on other sites More sharing options...
Iceman_40 Posted June 14, 2014 Author Share Posted June 14, 2014 Sure I'll gladly take a lend of one if one of you don't mind. Can't imagine I'll ever have to replace my swing arm twice lol Quote Link to comment Share on other sites More sharing options...
SR71BLACKBIRDXX Posted June 14, 2014 Share Posted June 14, 2014 Stand by... Quote Link to comment Share on other sites More sharing options...
Iceman_40 Posted June 25, 2014 Author Share Posted June 25, 2014 I'm assuming that the tool was made from a socket. What size socket was used to make it? Quote Link to comment Share on other sites More sharing options...
SR71BLACKBIRDXX Posted June 25, 2014 Share Posted June 25, 2014 Holy crap..I forgot all about this. Im such a dick. I made one and I 99% sure I still have it..give me till tomorrow Quote Link to comment Share on other sites More sharing options...
HANKSXXX Posted June 26, 2014 Share Posted June 26, 2014 1 1/8" SK 1/2" drive socket... I can loan you mine if Mike blanks out again...lol Quote Link to comment Share on other sites More sharing options...
Iceman_40 Posted June 26, 2014 Author Share Posted June 26, 2014 I'm assuming a 6 point 1 1/8th socket is the base? I don't think I'll get it in time if someone ships it. My bike needs the swing arm swapped before it gets shipped across the country only until next week to get it done. Quote Link to comment Share on other sites More sharing options...
HANKSXXX Posted June 26, 2014 Share Posted June 26, 2014 12 point that measures 1 7/16" OD I bought the socket, measured the width of the notches it had to fit in, cut out strips of tape slightly narrower than that width, ran the 2 pieces across the opening at a 90 degree angle, cut the exposed metal next to the tape with a cut off saw, and snapped the pieces I wanted gone off.Took a half hour.I also have a 5000 mile swing arm for sale that's like new from an 03 if anyone needs one. Quote Link to comment Share on other sites More sharing options...
SR71BLACKBIRDXX Posted June 26, 2014 Share Posted June 26, 2014 This is what I have. Made it myself. I ground flats on it so I could hold it with a wrench. I can get it out today if its not too late. Sorry.. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.