Warp11XX Posted September 11, 2006 Share Posted September 11, 2006 Anyone who installed an HID system got any creative ideas for mounting the ballast? I'm wedged and ty-wrapped to the crossbar behind the speedo right now. It is the only place I could reasonably find any room. :icon_wall: I'm wondering/worried if it will screw with the LCD in the speedo though? :icon_pray: I'm hoping not. :icon_hand: Waiting on a PIAA 85W super white to arrive for install on the high beam. This should be nice. Quote Link to comment Share on other sites More sharing options...
OrganDonor Posted September 11, 2006 Share Posted September 11, 2006 I zip tied the ignitors to the top bar running behind the speedo. The ballasts were attached with double sided tape to the inside of the top cowl, in an area where there wasn't anything else... there has been no problems with heat, nor with the speedo. Quote Link to comment Share on other sites More sharing options...
sykotek-xx Posted September 11, 2006 Share Posted September 11, 2006 FI bird, right? I used the supplied double sided tape pads and stuck them to the inside surfaces of the ram air ducts on each side of the dash. A bit back and down from the dash. I'll try to get some pics. No problem with the dash, but I did have a problem with my satellite radio reception until I moved that antenna to the tail cowl. Quote Link to comment Share on other sites More sharing options...
Flitemdic Posted September 11, 2006 Share Posted September 11, 2006 On the deck at the air inlets. I screwed mine down, too, but I'm a little anal that way. Quote Link to comment Share on other sites More sharing options...
beondwacko Posted September 11, 2006 Share Posted September 11, 2006 link to detailed pic. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.