Hi I bought the bike last year its got loads of miles and bit tatty it needed some tlc the brakes where fine but the rear disc was worn and their was a slight play in the bearing so pulled the back wheel did the bearings and disc and noticed the pots looked crusty with salt and stuff so I pulled the caliper the seals where good and pots cleaned up well with a rag I had to split the caliper to clean replaced the brakes next step changing the fluids being linked brakes I looked up the bleeding sequence removed the seat cowl to fill the ress and cracked the front right centre I got some of the old fluid through then nothing I was using a vac and pumping the rear brake it just stopped so iI removed the nipple and found the hole was blocked i cleared it got few mils of fluid though the pipe then nothing again i checked the nipple it was clear. Now here's the weird thing it will let me pull about 1inch fluid from the ress then no more im using a vac on the front right center the fluid lvl drops on the ress under the seat cowl about 1inch i keep trying for 1 hour and still cant get the fluid though so i pull the nipple the pessure drops out and a fluid lvl raises to the top again on the reservoir so i dont think anythings blocked I just cant get it to the caliper.
the fluid goes from the ress to the ms1 then pcv then ms2 then right front centre caliper I'm not shore if i need to service or bleed the m1 pcv ms2 until i get fluid to them if that possible The front brakes are working fine I will be doing a service once i get the back sorted and I get to go for ride.
Any thoughts guys ?