Help - Search - Members - Calendar
Full Version: Repacking Slip-ons
Public Discussion Forums > Mechanical/FAQ > The Garage
RC Randy
Thinking about repacking my Yoshi slip-ons after about 20k miles. If it is too much of a pain, I may just put the stockers back on.

Who makes a good long lasting material?

Do SAE rivets fit for reassembly?
blackhawkxx
Do they really need repacking? My Yosh's have close about 15 K on them and they don't need it. Also, mine have screws, yours have rivets?
RC Randy
Rivets and the sheet that came with them recommended repack every 15K. I think that there is material that never requires replacing, used either in Microns or Scorpions.
Pat830
After you are done with your Yosh's, come do mine. eusa_whistle.gif
The Krypt Keeper
remove screws or drill out rivets at the bottom at least on the last slip-on I repacked.

slide bottom along with perferated tube and packing out. Throw away old packing wrap with new packing material and slide all back into the muffler. Replace screws or install new rivets.

My Leo Vince's have 25k miles on them and thought about repacking them a yr or two ago. Then decided not too. They are like a fine wine, the more miles they get on them the sweeter the sound. Nice deep throaty sound.
jon haney
I wouldn't mess with it. Too much risk of damage.
I have a Yosh 4-1 system with over 40K miles on it that has never been touched. I'm sure it is a little louder than new, but I can't tell. It's still quieter than most after-market exhausts, especially below 4000 rpm.
tomek
There is no risks involved in repacking job.As a matter of fact it is not complicated at all.Drill out the rivets,disassemble,repack ( useful trick,use masking tape to hold fiberglass nice and tight before sliding it into a sleeve),reassemble.I think it takes 5mm or 1/5 inch rivets IIRC.

Start the bike,grab the cold one and enjoy nice and civilized again sound.

BTW,use latex,etc gloves before handling fiberglass.
The Krypt Keeper
I have always heard not to repack to tight as it will make the muffler louder. Needs to be not too tight or too loose. Kinda like a soft taco, to loose and all your shit falls onto your plate and too tight and you destroy the taco.

Keith
My Yoshi RS3s have over 25,000 miles on them and I have not noticed an appreciable
change in their loudness, although they do seem a bit more throaty now. I think they
improve with age and don't plan on repacking them any time soon.
cudgel
Who makes a good long lasting material?


Silent Sport Premium
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.
Invision Power Board © 2001-2012 Invision Power Services, Inc.