like a woman there are two holes in the frame.
and I don't want to put it in the wrong one.
one on top and one on the bottom.
anyone have a picture of the bird naked and can show me which hole to put it in?
le coq

Just find the old oil filter, unscrew it, and screw in the new "fram."

They aren't very good filters though... you're best off with a Honda branded one.

I use the honda filters, bought a few on ebay from some goldwing dealer.

OD can you help me out with the proper hole to screw in the FRAME slider?
Thank you

Ah.... good job. I see you edited the title of the thread, too. That "e" helps out.

watchoo talkin about willis
http://www.youtube.com/watch?v=Qw9oX-kZ_9k

Have you pulled the sides and looked at the possible locations?
The one I used are the only ones that you could use. They are the farthest rearward bolts in the motor mounts just infront of your knees. They have a resess hole in the frame. Almost at the point that the body turnes down.
Hell I did not know you were having trouble. I will go shoot some pictures and post them. Shit sorry.

here

No pics, but the lower engine bolts are the only accessible ones that I know of, and the pics posted look correct to me.

Here's a couple of photos showing installation points.



Click to view attachmentClick to view attachment

Thanks
much appreciated
I had photos of the sliders after the fairing was on but not while off.
Thanks for the help.
le coq

Be careful when you remove the engine mounting bolts, there is a spacer between the frame and engine that WILL disappear without you seeing it. I lost one and had to make a spacer out of washers.

I use frame sliders from here; http://www.motovationusa.com/ and I'm happy with them. So far I haven't tried them out but they seem like well made sliders. Just be sure to use a dab of Locktite on the new slider bolts when you reinstall them.



Yep, those are the ones I have.