Which bar ends fit the XX? Looking to replace my old and tired stock ones. Thanks in advance.

http://www.tricktape.com/subcatmfgprod.asp...&1=384&2=-1&6=1

Rich
StPeteXX

http://www.tricktape.com/product.asp?0=378&1=384&3=990

I would take them in silver..


Do you talk to Shawn when you call TT, Tell him some asshole in VA says hi :lol: He's a really good guy, finally got to meet him at the DC show earlier this yr.

I bought this http://www.tricktape.com/product.asp?0=203...03&1=232&3=1561 from him Friday.


Dave

If you want to save a couple of bucks, and get the "polished silver" look....

Remove your stock bar end weights, and mount it on a 2" piece of all-thread. Chuck this assembly into a drill press, and start sanding. Start with 100 grit wet (while it's spinning, dammit!) and work your way up to 800 grit wet. Now use some rubbing compound on a towel. By this point you should have a brilliant polished bar end. Spray it with some clearcoat so that it doesn't tarnish.

done.

For bar end weights, forget all that lame, cheesy stuff; you want the Good Shit:



13.5oz each, highly polished stainless steel, they are ultra bad-ass!

Here's where to score a pair: http://www.hvmparts.com/cbr-bar-ends.html

Those stainless steel bar ends are the shit. Do they reduce the little vibration that exists in the bars to about nothing? Hell who cares how they work they look goooood! :smokin:

Take a look at www.BarEnder.com
Not only do they look good but they are very functional too.
Also in about a week I will be able to get you a discount also.
You can even see them on my Bike at the FUXXT on Sunday.