Jump to content
CBR1100XX.org Forum
Pat830

Wanted : VFR bars for XX

Recommended Posts

Walt's nephew Garth wants some VFR bars for his XX.

 

If you have any to sell, PM me and I'll send you his email address or I can have him get in touch with you directly.

 

Thanks,

Pat

Share this post


Link to post
Share on other sites
On 10/19/2018 at 6:58 AM, blackhawkxx said:

It has been a while, does something need to be modded to work with those bars?

 

I did not do squat for mine. I have been told maybe the brake lines are too short? It has been a long time.

Share this post


Link to post
Share on other sites

Brakeline will reach but stresses it when steering turned to full lock.
Many have just ground off the little stop tab on the master cylinder to enable the banjo bolt to rotate slightly to reduce line stress.

  • Upvote 1

Share this post


Link to post
Share on other sites
7 hours ago, John01XX said:

Brakeline will reach but stresses it when steering turned to full lock.
Many have just ground off the little stop tab on the master cylinder to enable the banjo bolt to rotate slightly to reduce line stress.

That is what I was trying to remember but wasn't sure.  Being how I have my bike lower on the fork tubes, that might not be necessary?  I have Gaffer S.S. lines.

Share this post


Link to post
Share on other sites

That's been my experience.  If there's a clearance issue, rotate the brake line at the master, and take the bolt out of the clutch line that holds it to the steering neck and it all works.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×