Jump to content
CBR1100XX.org Forum

Stator plug


The Krypt Keeper

Recommended Posts

Usually check this plug once every couple years. I just checked it while the tail section was off and the plug shows the signs of failure in the making. 

 

My volt meter on the bike never showed any sign of fluctuations on my last ride so that is a good sign. Did a quick check of stator and R/R and both check out as well. 

 

Will need a new plug and pin connectors to install. Doubt honda sells these, anyone got a source to buy the 3 connector? 

 

Thanks

 

 

 

 

 

 

Link to comment
Share on other sites

Got a couple pics of what I found.. last time I checked the plug it looked brand new. 

 

Will end up removing about 2" or so of wire on the r/r side. 

 

All good, will have it fixed soon enough. 

 

Thanks for the link John, had been looking at some weatherproof ones from msd but cant find wire gauge size listed on amazon.

20170526_185532-1512x1361.jpg

20170526_183508_004-1512x2016.jpg

  • Upvote 1
Link to comment
Share on other sites

I recently changed stator and still have old one including wires and terminal. I can cut wires off stator and mail them to you. wires and block in good shape

 

 

Link to comment
Share on other sites

7 hours ago, fizzy said:

I recently changed stator and still have old one including wires and terminal. I can cut wires off stator and mail them to you. wires and block in good shape

 

 

 

I have a dead stator on the shelf back at the house too.   

... Don't recall the condition of the connectors though.

Link to comment
Share on other sites

10 hours ago, John01XX said:

John,

have you used this yet?

does it allow you to keep your OEM stator connector?

I have had a mosfet R/r sitting on the shelf for over a year, looking for connectors that would let me keep the stator plug OEM for a " just in case" field swap if I had a failure.

 

Going to order one today anyway.  But I had to ask.

Thanks for the link.

Link to comment
Share on other sites

6 hours ago, redxxrdr said:

John,

have you used this yet?

does it allow you to keep your OEM stator connector?

I have had a mosfet R/r sitting on the shelf for over a year, looking for connectors that would let me keep the stator plug OEM for a " just in case" field swap if I had a failure.

 

Going to order one today anyway.  But I had to ask.

Thanks for the link.

 

Good thought.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

Terms of Use