Jaygermeister

have you seen the regulations on hot water heater for this year? http://www.plumbingperspective.com/start-preparing-now-for-2015-energy-efficiency-rules-on-water-heaters/

take a hammer and ding the other side to match.......... all better. If you need anymore help I'll be here all week.

POS!!

Makers?

EVLXX's post that started this whole thing.......

J, is your low beam the projector? Or is the projector the High beam? The high beam has the projector but it's worthless now since I had to lower the head light to use the HID low beam

If you 2 don't mind waiting for a couple weeks... I might be inclined to make a few more of those shields. I currently have an order in for some special tubing... that may cut the production time down to a somewhat reasonable thing. then of course I will have to charge you a small fee... for building, packaging, and shipping.... say "A Million Dollars". I need one

............... not Bumble Bee too!

Yep, bad idea.... but will get you home. Now the real question is why did the Angel "blow out"?

I think I've only change the gasket once..... so only if it's damaged, change it

wait wait wait?? what??

:icon_doh:

Only one way to find out........ wink wink

Stopped in to get some much needed rubber mounted for an upcoming road trip and the place I go to was out of the tire I prefer so I thought I would mount my second choice (PR2 2CT) until I saw the PR3 2CT so I thought what the hell, I'll try them. I have not put one mile on them so my only impression is …… "Damn they are expensive" $400.42 mounted. My second impression is, they are ugly to look at. Anybody try them yet. Hope they are worth the coin.

:icon_lmao: ....... and you posted this in the for sale section to prove your point.