Jump to content
CBR1100XX.org Forum

Leaderboard

Popular Content

Showing content with the highest reputation on 12/31/2019 in all areas

  1. No fault codes? Idling, in neutral, with the FI light on, deploy the side stand. What happens to the light? Should flash the codes at that point. If it remains on then there is most likely a problem with the loom itself..or a connector. I have heard of wires breaking near the ECM. End of the road here is a new ECM. This happened to me (2000 with code 25) and I eventually had to obtain new ECM to fix it. Merry new year all
    1 point
  2. I remember this “place” as it was in the early 2000’s. It was pretty much no rules then.
    1 point
  3. What John said. Too cheap to fuck around. I helped a neighbor with HID issues recently, and after replacing one part, then the other, it seemed like they were causing each other to fail. No idea if that's possible, but that was the gut feeling. He's back on regular bulbs now. I have a set of LEDs for the XX, haven't tested them yet. If that would interest you, Oscar and I can fire one up with a whisky and a cigar in the garage later and give a driveway review.
    1 point
  4. The cap to the connector with the wires in it determines how your wires are grouped together. If you will look in the base of the cap at the spade connectors, you will notice that some are tied together, then there is a break in the electrical connection. That is how you decide how your wires are grouped together. I replaced mine and it had 18 wires in it also, but I guess I threw it away or I would take a better picture for you.
    1 point
×
×
  • Create New...

Important Information

Terms of Use